EGW Trijicon RMR / SRO, Holosun 407c / 507c Mount for Colt Gold Cup, Python, Anaconda

Mounting Hardware is Included

This mount fits:

• Colt Gold Cup
• Colt Trooper Mark 3
• Colt Python (does NOT fit 2020 and newer models)
• Colt Anaconda (does NOT fit 2020 and newer models)*

This is for Colt models with the Elliason style adjustable rear sight.

The elevation screw from the original rear sight is re-used in the center hole on this mount unless you have an Anaconda. An extra screw is available for purchase below as well.

*Anacondas require a new elevation screw due to the design of the elevation screw supplied with the gun.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.