Description
Mounting Hardware is Included
This mount fits:
- Elite Stock II with adjustable (LPA/Bomar style, shown above) rear sight
- Elite Stock III with adjustable (LPA/Bomar style, shown above) rear sight
- Hunter with adjustable (LPA/Bomar style, shown above) rear sight
- Limited Custom with adjustable (LPA/Bomar style, shown above) rear sight
- Limited Custom Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
- Match Elite with adjustable (LPA/Bomar style, shown above) rear sight
- Match Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
- P Match with adjustable (LPA/Bomar style, shown above) rear sight
- P Match Pro with adjustable (LPA/Bomar style, shown above) rear sight
- Stock II Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
- Stock III Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
This mount does not fit:
- EAA / Tanfoglio Witness with fixed rear sight
- EAA / Tanfoglio Witness with Novak style adjustable rear sight, shown above
Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
2 Flat Head Cap Screws - Provided for Trijicon RMR
The screws that are included with this mount require a 5/64'' allen wrench for installation.
