Description
Mounting hardware is included.
This mount fits:
Ruger SR9
Ruger SR9C
Ruger SR40
Ruger SR40C
Ruger SR45
This mount does not fit:
Ruger SR9E
Ruger SR22
Please note: Trijicon recommends the use of a sealing plate to prevent water from entering their red dots.
Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.78"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE407C X2 / HE507C / HE507C X2 / HS407C / HS407C X2 / HS507C / HS507C X2, Swampfox Kingslayer / Liberty / Justice
Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
The screws that are included with this mount require a 5/64'' allen wrench for installation.
Scope Mount Color Black Hardcoat Anodized Type III
Model SR9, SR45
Firearm Brand Ruger
Red Dot Brand Holosun 407C / 507C / 508T, Swampfox Kingslayer / Liberty / Justice, Trijicon RMR / SRO
