EGW Holosun K Series (fits Vortex Defender Series, Shield RMSC/RMS/SMS, Leupold DeltaPoint Pro) Mount for Bomar

This sight fits (including but not limited to):

• STI Edge (either this sight or LPA)
• Les Baer 1911 (adjustable rear sights)
• Colt Gold Cup Trophy with Bomar Rear Sight Cut
• Colt Gold Cup National Match .45acp
• Colt Gold Cup National Match 9mm
• Springfield TRP Operator
• Dan Wesson Bruin (may require fitting due to the Clark cut on the top of the slide)

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-48 X .313 Set Screw

Red Dot Fitment:

   
• Vortex Defender Series (Defender XL requires the screws provided by Vortex)
• OSight SE
• Bushnell RXS-100   
• Crimson Trace CTS-1500   
• Holosun 407K*
• Holosun 407k-GR
• Holosun 507K*
• Holosun 507k-GR
• Holosun EPS-GR*   
• Holosun EPS-RD*   
• Holosun EPS-Carry-GR*   
• Holosun EPS-Carry-RD*   
• Jpoint   
• Leupold Delta Point Pro   
• Optima   
• Redfield Accelerator   
• Shield RMS  
• Shield RMSc   
• Shield SMS   
• Sig Romeo Zero

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward).
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.