Description
Kensight Serrated Ramp Front Glock® Sight - SMALL and LARGE Frame
Because the Glocks rear dovetail, on the small and full frame, is small, shallow and not generally seen as ideal for an adjustable sight, it is anything but ideal for adding an adjustable. Knowing this, Kensight has designed one fully adjustable rear for all of the Glock pistols. Because the Glocks slide don't have a deep cut so that the fully adjustable sight with it's many mechanisms can "seat" down low enough to be paired with a standard height front.
All of the sights below are fully serrated from bottom to top and very simple to install with a single mounting screw (included) and a small bit of blue locktite if desired.
Front sight Kensight® item# 870-927. It is .315" tall, the minimum required for the adjustable rear, .100" wide. It is an all around good height and is a good height for target shooting at standard distances. Because it is our lowest height front sight, holstering is easier on a wider range of holsters than our other heights
Front sight is Kensight® item# 870-929. It is .330", .100" wide and .100" wide. This taller height is better for targets at longer distances.
Front sight is Kensight® item# 870-931. It is .350, the tallest of the three sights, and .100" wide. This sight was designed for again shooting at greater distances but to be paired with suppressors.
TECHNICAL INFORMATION:
- Material: 4140 Chrome Moly Steel
- Finish: Black Oxide
- Rear Sight Blade Type: Fully Serrated,
- 970-927 Dimension: .315 wide x .100 wide
- 970-929 Dimension: .330 wide x .100 wide
- 970-931 Dimension: .350" wide x .100" wide