Picatinny Rail for Savage Flat Back Short Action - 0 MOA
⚠️ CRITICAL: Savage made Flat Back receivers in Three lengths (Short, Medium, and Long). Your caliber (e.g., .308) does NOT guarantee you have a Short Action receiver.
✅ Fits ONLY: Receivers with exactly 3.93" spacing between the two middle holes.
❌ Does NOT Fit: Savage "Medium/J-Series" Actions (~4.52") or Long Actions (~5.06").
Mounting Hardware: #6-48 Screws (Included).
Bring your classic Savage 110 up to modern standards. If your rifle was made before 2003, it likely has a "Flat Back" receiver. However, identifying the correct size can be tricky because Savage produced these in Short, Medium, and Long lengths. This rail is specifically designed for the Short Action variant, which must have a center screw spacing of 3.93 inches.
Machined from domestic 6061 T6 aircraft aluminum, this rail is lightweight and rigid. The center channel reduces weight and allows you to use iron sights on some models. The full-length cross slots give you complete freedom to position your scope rings for proper eye relief—something often difficult to achieve on older Savage actions with two-piece bases.
- Rail Type: One Piece Picatinny (Compatible with Weaver rings)
- Machined From: Domestic 6061 T6 Aluminum
- Finish: Matte Black Anodize
- Center Spread: 3.93" (Center-to-Center of middle holes)
- Height: 0.4" (Top of receiver to top of rail)
- Mounting Hardware: #6-48 X 1/4 Screws & T-10 Bit Included
- Torque Specs: 20 in/lbs (Blue Loctite recommended)
|
Specifications:
|
Rail Type: One Piece Picatinny |
|
Scope Mount Color:
|
Black Anodized Type II
|
|
Material:
|
6061 Aluminum
|
|
Model:
|
Flat Back (Receiver) 110
|
|
Model:
|
Flat Back (Receiver) 112
|
|
Model:
|
Flat Back (Receiver) 111
|
|
Model:
|
Flat Back (Receiver) 114
|
|
Model:
|
Flat Back (Receiver) 116
|
|
Brand:
|
Savage
|
|
Minute Of Angle:
|
0 MOA
|
|
Action Length:
|
Short Action
|
|
GTIN:
|
841370105564
|
|
Mount Series:
|
Standard
|
|
Pin Selection:
|
Pin Set
|
|
Mounting:
|
 |
