EGW Red Dot Sight Mount for Smith and Wesson (S&W) M&P Shield EZ (fits Trijicon RMR / SRO, Holosun 407c / 507c)

Mounting Hardware is Included

This is a press fit mount. Utilization of a sight pusher tool may be required.

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

This mount fits:

• S&W M&P Shield EZ .380 ACP
• S&W M&P Shield EZ 9mm

This mount does not fits:

• S&W M&P
• S&W M&P 2.0
• S&W M&P 22

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.78"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

The screws that are included with this mount require a 5/64'' allen wrench for installation.