EGW Trijicon RMR / SRO, Holosun 407c / 507c Mount for LPA

Mounting Hardware is Included

This mount fits (including but not limited to):

• Sig Sauer 1911 Stainless Super Target*
• Sig Sauer 1911 Match Elite*
• Sig Sauer 1911 Target Full Size*
• Sig Sauer 1911 Max Full Size*
• STI with adjustable rear sights
• STI Trojan
• STI DVC 3 Gun
• STI DVC Limited
• STI DVC Classic
• Springfield Range Officer
• Springfield Range Officer Elite Target
• Springfield Loaded Target
• Rock Island TCM Rock Target FS HC Combo 22TCM / 9MM
• Rock Island Pro Match ULtra 5” - 45 ACP
• Rock Island Pro Match Tac Ultra 6” - 45 ACP
• Rock Island Pro Match Ultra HC - 40S&W
• Rock Island Pro Match Ultra 6” - 10MM
• Rock Island Pro Match ULtra 6” HC - 10MM
• Iver Johnson Eagle XL-SS10
• Iver Johnson Eagle SS-10
• Iver Johnson Eagle O.D. Green
• Iver Johnson Eagle Coyote Tan
• Iver Johnson Eagle XL-10 Ported
• Iver Johnson Eagle XL-10
• Iver Johnson Eagle XL-45 Ported
• Iver Johnson Eagle XL-45acp
• Iver Johnson Eagle LR

  *We have found that some Sig Sauer 1911's with adjustable rear sights use a Kimber Adjustable style rear sight cut. Please measure the distance from the top of the front of the dovetail to the face of the sight cut in your slide. If this measures .43" you will need this (LPA) mount. If it measures .415" you will need the Kimber Adjustable.*

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Minor modification may be neccessary for Rock Islands. Our products should be installed and checked by a qualified and competent gunsmith.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.