EGW Trijicon RMR / SRO, Holosun 407c / 507c Mount for Springfield XD, XDM

Mounting Hardware is Included

This mount fits:

• Springfield XD® MOD.2® – 3" SUB-COMPACT MODEL
• Springfield XD® MOD.2® – 3.3" SUB-COMPACT MODEL
• Springfield XD® MOD.2® – 4" SERVICE MODEL
• Springfield XD® MOD.2® – 4" SERVICE MODEL THREADED BARREL
• Springfield XD® MOD.2® – 5" TACTICAL MODEL
• Springfield XD® 3" SUB-COMPACT MODEL
• Springfield XD® 4" SERVICE MODEL
• Springfield XD(M)® 3.8" COMPACT MODEL
• Springfield XD(M)® 3.8" MODEL
• Springfield XD(M)® 4.5" MODEL
• Springfield XD(M)® 4.5" THREADED BARREL MODEL
• Springfield XD-S® 3.3" MODEL
• Springfield XD-E™ 3.3" SINGLE STACK
• Springfield Hellcat (NON OSP - NOT OPTIC READY)

Does not fit:

• Springfield XD(M)® 5.25" COMPETITION SERIES MODEL
• Any Optics Ready Springfield XD

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.