EGW Trijicon RMR / SRO, Holosun 407c / 507c Sight Mount Adapter for Springfield Hellcat Optics Ready

Mounting Hardware is Included

This mount fits:

• Springfield Hellcat Optics Ready
• Springfield Hellcat Pro Optics Ready

Please note: Trijicon recommends the use of a sealing plate to prevent water from entering their red dots.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware:
(2) 6-32 Flat Head Screws - Requires use of 5/64" Hex Key
(2) M4-0.7 x 8mm Flat Head Cap Screws - for mounting the plate to the slide - Requires use of 2.5mm Hex Key
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
-Remove optics plate
-Install EGW adapter plate
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.